L298N H-Bridge Dual Motor Driver, Stepper Motor Drive

৳ 150.00

This dual bidirectional motor driver is based on the very popular L298 Dual H-Bridge Motor Driver IC. This module will allow you to easily and independently control two motors of up to 2A each in both directions.

Out of stock

Category:

Description

Module pinouts
Consider the following image – match the numbers against the list below the image:

L298N Motor Controller for Arduino from Tronixlabs Australia

DC motor 1 “+” or stepper motor A+
DC motor 1 “-” or stepper motor A-
12V jumper – remove this if using a supply voltage greater than 12V DC. This enables power to the onboard 5V regulator
Connect your motor supply voltage here, a maximum of 35V DC. Remove 12V jumper if >12V DC
GND
5V output if 12V jumper in place, ideal for powering your Arduino (etc)
DC motor 1 enables jumper. Leave this in place when using a stepper motor. Connect to PWM output for DC motor speed control.
IN1
IN2
IN3
IN4
DC motor 2 enable jumper. Leave this in place when using a stepper motor. Connect to PWM output for DC motor speed control.
DC motor 2 “+” or stepper motor B+
DC motor 2 “-” or stepper motor B-

Customers' review

5 stars 0 0 %
4 stars 0 0 %
3 stars 0 0 %
2 stars 0 0 %
1 star 0 0 %

Reviews

There are no reviews yet.

Only logged in customers who have purchased this product may write a review.